Several key influencing factors of activated carbon for gold
Leave a message
Iodine value
The iodine value refers to the amount of iodine adsorbed by activated carbon in a 0.02N 12/KL aqueous solution. The iodine value is associated with the surface area of pores larger than 10A in diameter, and the iodine value can be understood as an indicator of the total pore volume.
Molasses value
Molasses value is a measure of the relative decolorization ability of activated carbon in boiling molasses solutions. Molasses values are interpreted as surface areas with pore diameters greater than 28A. Because molasses is a multi-component mixture, this parameter must be tested strictly according to the instructions. The molasses value is obtained by calculating the ratio of the optical density of the filtrate by treating the molasses liquor with the activated carbon standard and the activated carbon sample to be tested.
stacking weight
Bulk weight is a measure of the mass of a specific amount of carbon. By gradually adding activated carbon to a graduated drum to 100cc, and measuring its mass. This value is used to calculate the amount of activated carbon required to fill a particular adsorption unit. Simply put, bulk weight is the weight per unit volume of activated carbon.
particle density
Particle density is the weight per unit volume of granular carbon, excluding particles and spaces between cracks greater than 0.1 mm. Grain density is determined by displacement with mercury.
carbon tetrachloride
The carbon tetrachloride value is an indicator of total pore volume and is measured with a saturated gas stream of CCI4 at zero degrees Celsius through a carbon bed at 25 degrees. At specified time intervals, the weight of the adsorbed CCI4 was measured until the weight change of the sample was negligible.
methylene blue
The methylene blue value refers to the number of milligrams of methylene blue absorbed when 1.0 g of carbon and a methylene blue solution with a concentration of 1.0 mg/liter reach an equilibrium state.
hardness
Hardness is a measure of the mechanical strength of activated carbon. Change in weight, expressed as a percentage. More precisely, the hardness value refers to the resistance of granular activated carbon to the decay motion of steel balls in the RO-TAP instrument. The hardness value was calculated by using the weight of the char on the sieve after the char had been in contact with the steel balls.
Wear value
The wear value is an indicator to measure the wear resistance of activated carbon. This experiment measures the change in MPD, expressed as a percentage. The attrition values of granular activated carbon indicate that the particles reduce the resistance of the particles during processing. It is calculated by contacting a carbon sample with steel balls in a RO_TAP machine and measuring the ratio of the average diameter of the final particles to the average diameter of the original particles.
Butane number
The butane number is the amount of butane adsorbed per unit weight of activated carbon after saturated air and butane pass through the carbon bed at a specific temperature and a specific pressure.







